Maintenance Of Pressure Regulating Valve; Maintenance Of Linear Track; Maintenance Of Ball Screw - TECHCON SYSTEMS TSR2000 Series Hardware Instruction Manual

2. Take off the cover of Y-axis, clean the screw and track, check the screw if loose or not, spread lubricant on the
screw and track, move the Y-axis for spread more lubricant. Check the screw of light sensor. Then take on the
cover.
3. Take off the cover of Z-axis, clean the screw and track, check the screw if loose or not, spread lubricant on
the screw and track, move the Z-axis for spread more lubricant. Check the screw of light sensor. Then take on
the cover.
4. Belt: check if the belt is loosened. Adjust the belt if it loosened: firstly, disassemble the fixed screw. Secondly,
pull the motor back. Then press the belt 10N stress at the mid of the belt, bend 10~15mm. Finally fixed the
screws.
5. Check the linear rail straightness and accuracy. Adjust it if it is abnormal.
6. Replace the worn component.

6.1.5 Maintenance of pressure regulating valve.

1. Suggested working pressure is lower than 0.7 Mpa.
2. Drain regularly to keep the valve clean and dry.

6.1.6 Maintenance of linear track

Lubricate the linear track every 100km walking.
1.
2. Do not lubricate too much grease.
3. Inject the grease into the block. Do not straightly smear the grease on the surface of block
4. Prevent impurities getting into the inside from conjunction.
5. How to inject the grease:
① Stop the unit. Inject into the nozzle 0.7cc grease.
② Push the block for a round trip so that all the bead can be lubricated.
③ Repeat ①&②, inspect whether grease adhere to the end of track.
6.1.7

Maintenance of ball screw

1. Inject grease with grease gun by many times. Roll the screw spindle half-turn after injecting one time. Do not inject
rated grease, otherwise, it will not be lubricated completely.
2. Finished lubricating rated grease, Push the block for a round trip to spread grease.
32