Installation And Removal Procedures; Mounting Dimensions For The S7-1200 Devices - Siemens SIMATIC S7 System Manual

96BInstallation

3.3 Installation and removal procedures

3.3 Installation and removal procedures
3.3.1

Mounting dimensions for the S7-1200 devices

Table 3- 1 Mounting dimensions (mm)
S7-1200 Devices
CPU
Signal modules
Communication
interfaces
Because you must install a TS Adapter modular with the TS Adapter, the total width ("width A") is 60 mm.
1
Each CPU, SM, CM, and CP supports mounting on either a DIN rail or on a panel. Use the
DIN rail clips on the module to secure the device on the rail. These clips also snap into an
extended position to provide screw mounting positions to mount the unit directly on a panel.
The interior dimension of the hole for the DIN clips on the device is 4.3 mm.
42
CPU 1211C and CPU 1212C
CPU 1214C
Digital 8 and 16 point
Analog 2, 4, and 8 point
Thermocouple 4 and 8 point
RTD 4 point
Digital DQ 8 x Relay (Changeover)
Analog 16 point
RTD 8 point
CM 1241 RS232, CM 1241 RS485 and CM 1241 RS422/485
CM 1243-5 PROFIBUS master and
CM 1242-5 PROFIBUS slave
CM 1242-2 AS-i Master
CP 1242-7 GPRS
TS AdapterIE Basic
Width A Width B
90 mm 45 mm
110 mm 55 mm
45 mm 22.5 mm
70 22.5
70 mm 35 mm
30 mm 15 mm
60 mm 15 mm
1
S7-1200 Programmable controller
System Manual, 11/2011, A5E02486680-05