Ts (Teleservice) Adapter; Connecting The Teleservice Adapter - Siemens SIMATIC S7 System Manual

96BInstallation
3.3 Installation and removal procedures
Table 3- 14 Removing the female connector of the expansion cable
Task
3.3.8

TS (teleservice) adapter

3.3.8.1

Connecting the TeleService Adapter

Before installing the TS (Teleservice) Adapter IE Basic, you must first connect the
TS Adapter and a TS module.
Available TS modules:
● TS module RS232
● TS module Modem
● TS module GSM
● TS module ISDN
52
Procedure
1. Ensure that the CPU and all S7-1200 equipment are
disconnected from electrical power.
2. Unlock the connector:
– Place a screwdriver beside the tab on the top of
the signal module.
– Press down slightly and slide the tab fully to the
right.
3. Lift the connector up slightly to disengage the hook
extension.
4. Remove the female connector.
System Manual, 11/2011, A5E02486680-05
S7-1200 Programmable controller