Trouble-Shooting And Maintenance - Weider WESY19002 User Manual

TROUBLE-SHOOTING AND MAINTENANCE

Make sure all parts are properly tightened each time you use the training system. Replace any worn parts immedi-
ately. The training system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
TIGHTENING THE CABLES
23
Woven cable, the type of cable used on the training
system, can stretch slightly when it is first used. If
78
there is slack in the cables before resistance is felt,
the cables should be tightened.
2
Slack can be removed from the cables by tightening
the Short Cable (23). To tighten the Short Cable, first
loosen the 1/4" Nylon Locknut (2) on the end of the
Short Cable. Next, tighten the end of the Short Cable
further into the "U" Bracket. Retighten the 1/4" Nylon
Locknut against the 1/4" Washer (78).
To remove slack from the Long Cable (69), remove
the "V"-Pulley (6) and the Cable Trap (not shown)
from the Seat Frame (36). Reattach the Pulley and
the Cable Trap to a hole further back in the Seat
6
36
Frame.
Make sure that the cables are not too tight, or the top
weight will be lifted off the weight stack.
If the cables need to be replaced, see the back cover
of this manual.
69
20