Weider WESY19002 User Manual page 8

1. Press a 1 1/2" x 2 1/2" Outer Cap (73) onto
each end of the Stabilizer (5). Press a 1 1/2" x
2 1/2" Inner Cap (27) into the indicated end of
the Base (4).
Attach the Base (4) to the Stabilizer (5) using
two 3/8" x 2 1/4" Carriage Bolts (1) and two
3/8" Nylon Locknuts (21). Make sure that the
Base is oriented exactly as shown.
2. Insert the Weight Guides (62) into the indicated
holes in the Base (4) and the Stabilizer (5).
Attach the Weight Guides to the Base and the
Stabilizer using two 5/16" x 3 1/4" Bolts (14),
two 5/16" Washers (70), and two 5/16" Nylon
Locknuts (3).
3. Attach the Front Upright (42) to the Base (4)
using two 3/8" x 2 1/4" Bolts (1) and two 3/8"
Nylon Locknuts (21). Do not tighten the
Nylon Locknuts yet.
4. Slide a Weight Bumper (19) down over each
Weight Guide (62).
Slide the Weights (25) onto the Weight Guides
(62). Make sure all of the Weights are ori-
ented exactly as shown, with the deep pin
grooves on the bottom.
1
21
5
1
73
2
62
14
70
70
3
3
4
4
62
25
19
8
4
73
5
3
4
42
21
1
Pin
Groove
27