Trouble-Shooting And Maintenance - Weider WESY99490 User Manual

Weider user's manual pro 9935 home gym wesy99490
Table of Contents

Advertisement

Trouble-shooting and Maintenance

Inspect and tighten all parts each time you use the home gym. Replace any worn parts immediately. The
home gym can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
Tightening the Cables
Woven cable, the type of cable used on the home gym,
can stretch slightly when it is first used. If there is slack in
the cables before resistance is felt, the cables should be
tightened.
Note: If a cable slips off the pulleys often, the cable
may have become twisted. Remove the cable and re-
install it.
If the cables need to be replaced, see ORDERING
REPLACEMENT PARTS on the back cover of this manual.
Slack can be removed from the cables in several different
ways:
The Adjustable Pulley Plates (23) have several sets of
adjustment holes. By moving one or both pulleys (24) to a
different set of holes, you will tighten the cables.
To move a Pulley (24), remove the 3/8Ó Nylon Locknut
(50) and the 3/8Ó x 2Ó Bolt (54). Remove the Cable Trap
(25) and Pulley from the Adjustable Pulley Plates (23).
Re-attach the Pulley and Cable Trap to the appropriate
adjustment hole in the Pulley Plates. Note: Begin by
moving one Pulley to the second adjustment hole. If
the cables are still too loose, move the same Pulley to
the third hole. If additional adjustment is needed,
move the other Pulley until the cables are tight.
Slack can be removed form the Press Cable (72) by mov-
ing one or both of the ÒVÓ-Pulleys (27) on the Press
Cable.
One ÒVÓ-Pulley (27) is attached to the small tube on the
Press Upright (2). There are three free holes in the small
tube, and you can move the ÒVÓ-Pulley to any one of them
to tighten the cables. Start by moving the ÒVÓ-Pulley one
hole, and then one more, as needed.
The second ÒVÓ-Pulley (27) is attached to the Press Seat
Frame (7). There are five adjustment holes in the Seat
Frame. By moving the ÒVÓ-Pulley closer to the Press
Upright (2), you will tighten the cables. By moving it fur-
ther away from the Upright, you will loosen the cables.
.
23
54
24
7
72
26
Adjustment
Holes
50
25
2
27
27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents