Arm Assembly - Weider WESY13820 User Manual

ARM ASSEMBLY

5. Press two 25mm x 50mm Inner Cap (42) into the
top of the Press Frame (9). Press two 50mm
Square Inner Caps (44) into the ends of the
Press Frame.
Orient the Press Frame (9) with the bracket on
the side shown. Attach the Press Frame to the
Top Frame (5) with an M10 x 125mm Bolt (54),
two M10 Washers (55), and an M10 Nylon
Locknuts (56).
6. Press a 45mm Square Inner Cap (45) into the
end of the Right Arm (10). Press a 25mm Round
Inner Cap (43) into the tube on the Arm.
Wet the end of the Right Arm (10) with soapy
water. Slide a Large Foam Pad (19) onto the Arm.
Slide an Arm Grip (34) onto the handle on the
Right Arm (10). Press a Dome Cap (47) into the
end of the handle.
Repeat this step with the Left Arm (not
shown).
7. Slide an Arm Bushing (46), with the lip on the bot-
tom, onto the post on the Right Arm (10). Insert
the post through the hole in the Press Frame (9).
Be sure the Arm is behind the indicated brack-
et on the Press Frame.
Slide a Large Washer (67) over the post on the
Right Arm (10) and attach an M6 x 43mm Bolt
(57) to it with an M6 Nylon Locknut (58). Be sure
the Locknut and the head of the Bolt are over
the edge of the Washer, as shown in the inset
drawing.
Press a 25mm Round Inner Cap (43) into the top
of the post on the Right Arm (10).
Repeat this step with the Left Arm (11).
5
6
10
Handle
47
19
7
43
67
46
Lip
58
7
5
54
42
55
56
55
Bracket
9
44
45
43
34
11
9
57
Bracket
Post
10
Post
57
67
44
58