Seat Assembly - Weider WECCSY24540 User Manual

34. Wrap the High Cable (54) under a 90mm Pulley
(46). Attach the Pulley and a Cable Trap (48) to
the Base (1) with an M10 x 48mm Bolt (86), an
M10 Washer (77), and an M10 Nylon Locknut
(80). Make sure the Cable Trap is turned to
hold the Cable in the groove of the Pulley.
35. Route the High Cable (54) through the Front
Upright (5), the Front Leg (7), and the Leg Lever
(15).
Attach a 90mm Pulley (46) inside the Front Leg
(7), over the High Cable (54), with an M10 x
67mm Bolt (65), two 12.5mm Spacers (59), two
M10 Washers (77), and an M10 Nylon Locknut
(80).
36. Attach a 90mm Pulley (46) inside the Leg Lever
(15), over the High Cable (54), with an M10 x
67mm Bolt (65), two 12.5mm Spacers (59), two
M10 Washers (77), and an M10 Nylon Locknut
(80).

Seat Assembly

37. Attach a Seat (20) to the Seat Frame (8) with two
M6 x 16mm Screws (67), an M6 x 65mm Screw
(81), and an M6 Washer (74).
34
77
86
46
54
35
5
65
36
59
65
37
17
80
48
1
15
7
54
46
77
80
59
77
59
15
80
59
77
46
77
20
8
74
81
67
54