Noise And Vibration - Flex MS713 Original Operating Instructions

MS713
Safety instructions for orbital sander
WARNING!
Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electric shock,
fire and/or serious injuries . Save all
warnings and instructions for future
reference.
 Always disconnect the sander cord plug
from the power circuit before changing
abrasive sheets!
 Use dust mask! Wear a protective mask
to minimize breathing in the fine dust
created while sanding.
 Never run sander with dust container or
dust collector assembly removed!
Otherwise, very fine dust particles could
be blown into the eyes.
 Use proper safety equipment!
Wear safety goggles to protect your eyes.
 Sanding of lead-based paint is not
recommended.
Lead paint should be removed by
a specialist only.
 Use of this tool can generate and
disburse dust or other airborne particles,
including wood dust, crystalline silica
dust and asbestos dust. Direct particles
away from face and body.
Always operate tool in well ventilated
area and provide for proper dust
removal. Use dust collection system
wherever possible. Exposure to the dust
may cause serious and permanent
respiratory or other injury, including
silicosis (a serious lung disease), cancer,
and death. Avoid breathing the dust, and
avoid prolonged contact with dust.
Allowing dust to get into your mouth or
eyes, or lay on your skin may promote
absorption of harmful material. Always
use properly fitting NIOSH/OSHA
approved respiratory protection
appropriate for the dust exposure, and
wash exposed areas with soap and
water.
Additional safety instructions
The mains voltage and the voltage
specifications on the rating plate must
correspond.

Noise and vibration

NOTE
Values for the A weighted sound pressure
-
level and for the total vibration values can be
found in the "Technical specifications" table.
The noise and vibration values have been
determined in accordance with EN 60745.
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in
EN 60745 and may be used to compare one
tool with another. It may be used for a
preliminary assessment of exposure. The
declared vibration emission level represents
the main applications of the tool.
However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission may
differ. This may significantly increase the
exposure level over the total working period.
However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission may
differ.
This may significantly decrease the exposure
level over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories,
keep the hands warm, organisation of work
patterns.
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A).
13