Instructions For Use - Flex MS713 Original Operating Instructions

Instructions for use

WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Before switching on the power tool
Unpack power tool and accessories and
check that no parts are missing or damaged.
Switching on and off
CAUTION!
Make certain the switch is in the "O" position,
and the power source is the same as that
specified on the tool's nameplate.
1. Connect the tool to the power source.
2. The switch button is labeled "I" and "O".
Depress the "I" end of the switch button to
start motor. Depress the "O" end of the
switch button to stop motor.
16
Attaching hook & loop abrasive
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug!
To install hook & loop abrasives, align the
abrasive with the sander pad and press in place.
Attaching conventional abrasive
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug!
1. Open paper clamp by Iifting up on Iever (A)
to release it from the locking tab (B).
MS713