Removing The Sensor Board; Prerequisites; Procedure - Dell Inspiron 13 5000 Service Manual

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
•

Prerequisites

•

Procedure

Prerequisites
1. Remove the base cover.
2. Remove the battery.
3. Remove the display assembly.
4. Follow the procedure from step 1 to step 3 in
Procedure
CAUTION: Place the display-panel assembly on a soft and clean surface to avoid scratching the display.
1. Remove the screw (M2.5x2.5) that secures the sensor board to the display panel.
2. Peel off the tape and open the latch to disconnect the sensor-board cable from the sensor board.
3. Lift the sensor board off the display panel.
Figure 36. Sensor board
1. sensor board

Removing the sensor board

computer. After working inside your computer, follow the instructions in
"Removing the display panel".
2. screw
Removing the sensor board
47
After
75