NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Prerequisites
1. Remove the
base
cover.
2. Remove the battery.
3. Remove the
display
assembly.
4. Follow the procedure from step 1 to step 2 in
Procedure
CAUTION:
Place the display-panel assembly on a soft and clean surface to avoid scratching the display.
1. Place the display-panel assembly face down on a flat surface.
2. Remove the screw that secures the sensor board to the display panel.
3. Peel off the tape that secures the sensor-board cable to the sensor board.
4. Open the latch to disconnect the sensor-board cable from the sensor board.
5. Lift the sensor board off the display-panel assembly.
Figure 41. Removing the sensor board
1. tape
78
Removing the sensor board
Removing the sensor board
computer. After working inside your computer, follow the instructions in
"Removing the display
2. latch
panel".
47
After
www.dell.com/