NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
CAUTION:
Hard drives are fragile. Exercise care when handling the hard drive.
CAUTION:
To avoid data loss, do not remove the hard drive while the computer is in sleep or on state.
Topics:
•
Prerequisites
•
Procedure
Prerequisites
1. Remove the
base
cover.
2. Remove the battery.
Procedure
1. Peel off the tape that secures the hard-drive cable to the palm-rest assembly.
2. Using the pull tab, disconnect the hard-drive cable from the system board.
3. Remove the two screws (M2x3.5) that secure the hard-drive assembly to the palm-rest assembly.
4. Lift the hard-drive assembly, along with its cable, off the palm-rest assembly.
Figure 7. Hard drive
1. tape
3. palm-rest assembly
5. system board
Removing the hard drive
computer. After working inside your computer, follow the instructions in
2. hard-drive assembly
4. screws (2)
6. hard-drive cable
After
Removing the hard drive
9
21