Setting The Humidity Level - 3B Medical Line II QX Series User Manual

Luna II QX CPAP / Luna II QX Auto CPAP User Manual V1.1
Luna II QX CPAP / Luna II QX Auto CPAP User Manual V1.1
CAUTION!
• Empty and air-dry the water chamber when the device is not in use.
(3) Inserting the Water Chamber according to instructions in 13.1.3.

14.3 Setting the Humidity Level

After the device is powered on, turn the Knob
to turn on or turn off the heated
humidifier and to adjust the humidity level according to instructions on the screen of
the device.
There are five humidity levels available, and the number of blue indicator lights that
light up is directly proportional to the humidity level. If none of the indicator lights
light up, it means that the heated humidifier is turned off.
The temperature of the water in the water chamber maintains a constant set level.
Three indicator lights light up when the humidity is adjusted to Level 3, as shown in
Fig. 13-7.
Indicator
Humidifier
Fig. 14-7
CAUTIONS!
• Generally speaking, the humidity inside the mask is low when the water
temperature is low.
• The greater the difference between the temperature inside the air tubing and
room temperature is, the more easily condensation occurs inside the tubing.
• If there are only a few condensed water droplets inside the tubing in the morning
after therapy, it means that the humidity level is appropriate; if there is lots of
condensed water droplets inside the tubing and / or mask, it means that the
humidity level is too high and should be set lower; Nasal dryness means that the
humidity level is too low and should be set higher.
WARNING!
• Do not touch the heater plate of the device when it is working, otherwise you may
get burned. Turn off the heat when the heated humidifier is not in use.
20
20 / 41