First Time Setup; Placing The Device - 3B Medical Line II QX Series User Manual

Luna II QX CPAP / Luna II QX Auto CPAP User Manual V1.1
Luna II QX CPAP / Luna II QX Auto CPAP User Manual V1.1
SD Card Slot
Air Outlet
Name
SD Card Slot
Air Outlet
Communications
Port
DC Inlet
Filter Cap (Air Inlet)

12. First Time Setup

12.1 Placing the Device

Place the device on a firm, flat surface.
WARNINGS!
• If the device has been dropped or mishandled, if the enclosure is broken, or if
water has entered the enclosure, disconnect the power cord and discontinue use.
Contact your home care provider immediately.
• If the room temperature is warmer than 95°F (35°C), the airflow produced by the
device may exceed 109.4°F (43°C). The room temperature must be kept below 95°F
(35°C) while the patient uses the device.
CAUTIONS!
• If the device has been exposed to either very hot or very cold temperatures, allow
it to adjust to room temperature (approximately 2 hours) before beginning setup.
• Make sure the device is away from any heating or cooling equipment (e.g.,
forced air vents, radiators, air conditioners).
• The device is not suitable for use in high humidity environments. Make sure that no
water enters the device.
• Make sure that bedding, curtains, or other items are not blocking the filter or vents
of the device.
• Keep pets, pests or children away from the device and avoid small objects being
inhaled or swallowed.
Fig. 11-2
Insert the SD card into this slot
Deliver pressurized air; connects to the tube
Connected to external equipment (Not for connection to
un-recommended devices)
An inlet for the DC power supply
Place the cap on the air filter, which is used to filter dust and
pollen in the air entering the device
11
11 / 41
Communications Port
DC Inlet
Filter Cap (Air Inlet)
Function