Assembling The Tube And Mask - 3B Medical Line II QX Series User Manual

Luna II QX CPAP / Luna II QX Auto CPAP User Manual V1.1
Luna II QX CPAP / Luna II QX Auto CPAP User Manual V1.1
WARNINGS!
• The device is powered on for use when the power cord and power adapter is
connected. The Knob
• Use of the device at an AC voltage beyond the stated range (see Section 5 "AC
Power Consumption") may damage the device or cause device failure.
• Connect to appropriate power for proper operation of the device.
CAUTION!
• Inspect the power cord often for any signs of damage. Replace a damaged cord
immediately.
IMPORTANTS!
• After interruption and restoration of the power supply, the device will restore its
pre-interruption working status automatically.
• To remove AC power, disconnect the power cord from the power outlet.

12.4 Assembling the Tube and Mask

(1) Connect one end of the tube to the air outlet of the device, as shown in Fig.
11-4.
Air Outlet
Tube
Power Adapter
Power Cord
Fig. 12-3
turns the blower On / Off.
Fig. 12-4
13
13 / 41
DC Inlet