Table of Contents
Advertisement
Supported expansion card options
Table 8. Supported expansion cards
Card type
Foxconn (miniPERC for boot)
Broadcom (OCP NIC: dual port 25 GbE SFP28)
Intel (OCP NIC: dual port 10 GbE Base T)
Intel (NIC: dual port 25 GbE)
Mellanox (NIC : dual port 25 GbE)
Nvidia (GPU: 16 Gb)
Nvidia (GPU: 32 Gb)
Nvidia (T4 GPU: 16 Gb)
MiTAC (FE1 card)
Inventec (PERC H745 for storage )
Cable M.2 riser board
Removing the cable M.2 riser board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the
sled.
4.
Remove the air
shroud.
Steps
1. Using the Phillips #1 screwdriver, remove the screw that secures the M.2 riser board into system board.
2. Pull out the M.2 riser board.
3. Disconnect the slimSAS cables from the M.2 riser board slots.
NOTE:
Observe the routing of the cable as you remove the M.2 riser board.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Card
priority
1
2
3
4
5
6
7
8
9
10
Safety
instructions.
Before working inside your
Slot
Maximum number of cards
priorit
y
1
1
3
1
3
1
4
1
4
1
4
1
4
1
4
1
4
1
5,6
2
system.
Installing and removing system components
57
Hide quick links:
Advertisement
Table of Contents
