Motherboard Interposer Board; Removing The Motherboard Interposer Board - Dell EMC PowerEdge XE7440 Installation And Service Manual

Figure 40. Installing the motherboard bridge module
Next steps
1. Install the cooling fans.
2. Install the cable M.2 riser
3. Install the mini PERC card
4. Install the PCIe dummy
5. Install the air shroud.
6. Install the sled.
7. Follow the procedure listed in

Motherboard interposer board

Removing the motherboard interposer board

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the sled.
4. Remove the air shroud.
5. Remove the PCIe dummy
6. Remove the mini PERC card
board.
module.
bracket.
After working inside your
Safety instructions.
Before working inside your
bracket.
module.
system.
system.
Installing and removing system components 75