Table of Contents
Advertisement
Quantity
Additional Parts for the SP wing
1
1/32" x 18" music wire
1
6" heat shrink tubing
1
88" Plastic strapping
1
1/16" plywood control horns sheet
1
1/32" plywood control horn reinforcement sheet
2
Depron ailerons
General Building Tips
•
Use only foam safe glue to attach the foam sections. Regular CA will dissolve the
foam.
•
Don't remove any pieces from the balsa sheets until they're ready to be used. That
way, parts won't get mixed up or disappear.
•
After you remove pieces from the balsa sheets, carefully remove any of the extra
material from where the piece was attached.
•
Don't over force your pieces together. If they aren't going together properly, make
sure you have the right pieces and that they are oriented correctly.
•
If you want to remove the charred edges caused by the laser cutting process,
dampen a cloth with bleach and gently rub the affected areas. Removing the char
will not increase the strength but will make it look better.
Assembly Instructions
Step 1: Assemble the Wing
The first thing you are going to assemble is the wing of your airplane. This involves
assembling the wing halves, attaching the spar strips, and then applying the packing tape.
Both the SF and SP wing build the same. The SP wing has less dihedral than the SF wing
and has ailerons. The ailerons will be covered later.
Do not let non-foam safe CA touch the foam. Regular CA will dissolve the foam.
1. Glue the wing halves together with 5 minute epoxy. You can hold them together
with tape while the glue sets. Be sure that the two halves line up correctly. Do not
worry about the dihedral angle. The wings are cut with the proper angle at the
factory.
Mountain Models Magpie
Description of Part
3
Advertisement
Table of Contents
