Diagnostics Function Group - Filtec FT-70 Operation Manual

Note
Industrial Dynamics Company, Ltd. Document 40274-0600
Line Speed (cpm)
The speed of the production line measured by cpm (containers per
minute). The measurement is the number containers that intercept
the FT-70/75's trigger beam in 60 seconds. To calculate cpm from
cph (containers per hour) use the following formula:
Line Speed (cph)
The speed of the production line measured by cph (containers per
hour). The measurement is the number containers that intercept
the FT-70/75's trigger beam in 60 minutes. To calculate cph use the
following formula:

Diagnostics Function Group

Displays the current diagnostic error. Clearing the error stops the
Signal Beacon from flashing and the Remote Alarm PLC output
signal.
How to Access Diagnostic Error Codes
Do not use the Reset Switch to clear diagnostic errors.
To view the error:
1. Press Key 6 to display the current diagnostic error number.
2. Press the Arrow Key to scroll through the error definition.
3. When you reach the end of the message, press the Arrow Key
once again to clear the error.
For more information see "Chapter 4: Diagnostics and
Troubleshooting".
Chapter Three: Using the System Software
cph
--------- - = cpm
60
×
cpm 60 cph
=
3-15