Software Function Descriptions; Fill Level Functions Group - Filtec FT-70 Operation Manual

FT-70/75 Fill Level Inspectors Operator's Guide

Software Function Descriptions

3-8
This section contains function descriptions for each function
group. Depending upon your FT-70/75 machine type, machine
configuration, and options package, some of these options may not
apply to your FT-70/75.

Fill Level Functions Group

X-ray Source Status
This function activates or deactivates the X-ray Generator. When
the X-ray Status is off Error 123 displays and the warning beacon
flashes.
The X-ray Status is automatically disabled when the Safety
Interlock Switch is turned off. To turn the X-ray Status back on you
must:
1. Turn the Safety Interlock Switch on.
2. Press Key 1 until X-RAY Source appears.
3. Press the Arrow Key to turn the X-ray Source Status on. The
generator will take approximately 5 seconds to reach full
power and begin generating of x-rays.
Underfill Reject Status
This function activates or deactivates the rejection of underfilled
containers. Deactivating this function inhibits the rejection of
containers with fill levels below the Underfill Threshold. It does
not turn off underfill inspection, it only stops the rejector from
rejecting underfills. Underfill and Overfill can not be active simul-
taneously on the FT-70.
Overfill Reject Status
This function activates or deactivates the rejection of overfilled
containers. Deactivating this function inhibits the rejection of
containers with fill levels above the Overfill Threshold. It does not
turn off overfill inspection, it only stops the rejector from rejecting
overfills. Underfill and Overfill can not be active simultaneously
on the FT-70.
Industrial Dynamics Company, Ltd. Document 40274-0600