Diagnostics Function Group - Filtec FT-50 Operation Manual

FT-50 Fill Level Inspector Operation Guide
Note
3-12
Line Speed (cpm)
The speed of the production line measured by cpm (containers per
minute). The measurement is the number containers that intercept the
FT-50's trigger beam in 60 seconds. To calculate cpm from cph
(containers per hour) use the following formula:
Line Speed (cph)
The speed of the production line measured by cph (containers per hour).
The measurement is the number containers that intercept the FT-50's
trigger beam in 60 minutes. To calculate cph use the following formula:

Diagnostics Function Group

Displays the current diagnostic error. Clearing the error stops the signal
beacon from flashing and the remote alarm PLC output signal.
How to Access Diagnostic Error Codes
Do not use the Reset Switch to clear diagnostic errors.
To view the error:
1. Press Key 6 to display the current diagnostic error number.
2. Press the Arrow Key to scroll through the error definition.
3. When you reach the end of the message, press the Arrow Key once
again to clear the error.
For more information see "Chapter 4: Diagnostics and Troubleshooting."
cph
-------- -
= cpm
60
×
cpm 60 = cph
Industrial Dynamics Company, Ltd. Document 40272-0700