Setup Units; Setup Operation; Setup Limits - MGL Avionics Stratomaster Maxi Single Flight II Manual

We recommend that you choose automatic flight logging.
Fuel level ...
If the instrument is operating with an external fuel level sender, then this entry will show the
current fuel level, you cannot edit the entry.
If you have selected to operate with a fuel flow sender only, then you can use this function to set
your current fuel level. As the flow sender detects flow, the level will decrease accordingly
(calculated fuel level).
Units are as selected in the "Setup Units" menu (Liters or U.S. Gallons).
Trip Zero
Select this function to set your air distance trip counter to zero. Note that you can select to set the
counter to zero automatically as a new flight is started. Regardless of this, you can set the
counter to zero at any time.
View Flight log
Entering this function will allow you to view the entries in your flight log. The instrument will
maintain a log of your last 60 flights. Each log entry contains date and time of your take-off,
duration of the flight, maximum altitude and airspeed reached and also the reading of your engine
Hobbs meter at the end of the flight.
Contrast ...
This function allows you to change the display contrast to your liking. You can select values from
about 20 to 45. (can vary depending on display type).
Typical values are around 35.
Backlight ...
This function allows you to switch the display backlight on or off. We recommend that you leave
the backlight switched on unless you need to conserve power.

Setup Units

This enters a menu where you can select units for various measurements.

Setup Operation

This enters a menu where you can select the various modes of operation.

Setup Limits

This enters a menu where you can set various alarm levels and operating limits.