Unload Filament - Flashforge Creator 3 Quick Start Manual

Unload Filament

Build
1. Tap[Tools], [Filament] to enter the filament interface.
Load
Left Extruder
Right Extruder
2. Tap the unload switch after corresponding
extruder to unload corresponding extruder.
4. Pull filament guide tube out of filament intake,
leave filament 10cm to pull filament easily.
Please follow steps below if you need to unload filament in
daily use.
Preheat Tools
Unload
Left Extruder
Right Extruder
Begin
Withdraw
Filament
Guidetube
Filament
Setting
Left Extruder is Heating...
31%
69℃ / 220℃
<
3. Tap[Begin], the extruder will start heating.
The printer will start unloading filament
after heating completed.
Press here
5. Press spring presser and push filament
down through for 3 seconds, then pull out
vertically quickly.
16
HOME
Level Home
Status About
Right Extruder is Heating...
31%
69℃ / 220℃
Cancel
Push filament
down through
for 3 seconds
Manual
<
<