Load Filament - Flashforge Creator 3 Quick Start Manual

Build
1. Tap[Tools], [Filament] to enter the filament interface.
Load
Left Extruder
Right Extruder
2. Flip the switch after corresponding extruder to
load corresponding extruder.
Left Extruder Heated
Loading started, push filament vertically
into extruder and press [Done] when you
see filament come out of the extruder
4. Once heated, filament will be drawn through the extruder. Continue extruding until the extruder
provides a steady flow of filament. Tap [Done], go back. Tap leftwards arrow to go back to the
home screen.
Attetion: If extruder can not unload in a long time, please check if you have inserted filament
into the bottom of extruder.

Load Filament

Preheat Tools
Unload
Left Extruder
Right Extruder
Begin
Right Extruder Heated
Done
Filament
Setting
Left Extruder is Heating...
31%
69℃ / 220℃
<
3. Tap[Begin], the extruder will start heating.
<
11
HOME
Level Home
Status About
Right Extruder is Heating...
31%
69℃ / 220℃
Cancel
Manual
<
<