Flashforge Creator 3 Quick Start Manual page 9

Build
1. Tap[Tools], tap[Level]to level the build plate.
2. Wait for the extruder and the build plate moving, after moving completed, choose to use which
extruder to level the build plate: left or right.
Please wait...Initializing
3. After leveling extruder confirmed,extruder will move to the first point to verify the distance
between nozzle and build plate. If verify completed, extruder will move to the second point to
verify the distance.
Wait
Turn the nut counterclockwise 90°
Verify
4. If the distance is not appropriate, please follow the prompts to adjust again till you see [OK] button.
Repeat steps 4 to level the second and third points. Then tap [Finish] to exit.
Preheat Tools
OK
Next
Filament
Setting
Level
Left Extruder
<
Verifying the distance between nozzle
<
Wait
07
HOME
Level Home
Status About
Select the extruder
Right Extruder
and plate...
Wait
Turn the nut clockwise 45°
Verify Next
Manual
<
<