Coffee/Beverage Dispensing; Stop" Dispensing Coffee/Beverage; Emptying The Dreg Drawer; Dispensing Steam - LAVAZZA Blue LB2200 Instructions For Installation And Use Manual

Hide thumbs Also See for Blue LB2200:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 18
10:30
11 Feb 04
The display will show:
Ready
Select product
Warning! If you meet with any resistance when closing the tray,
check the position of the pod.
It is forbidden to place fingers or any object other than a Lavazza
pod inside the tray.
At this point the pod has been inserted and the user is prompted to select the
desired drink.
4.5

Coffee/beverage dispensing

Before dispensing a coffee/beverage make sure that:
1 The machine is warmed up;
2 the pod has been correctly positioned;
3 a cup suitable for the selected product is placed beneath the dispensing
tube.
4 the required amount has been inserted (machines with coin mechanism only).
Making espresso (Fig.12)
Press the espresso button. The machine will automatically brew the coffee. On
reaching the quantity programmed by the service provider, the machine will
automatically stop dispensing coffee.
Making a large coffee (Fig.13)
Press the large coffee button. The machine will automatically brew the coffee.
On reaching the quantity programmed by the service provider, the machine will
automatically stop dispensing coffee.
Manual dispensing (Fig.14)
Press the manual dispensing button. The machine will automatically start
dispensing the selected product; the machine must be stopped by pressing
the "Stop" button.
Note: if the stop button is not pressed, coffee may overflow from
the cup; in any case, the machine will stop dispensing on reaching
the maximum quantity programmed by the manufacturer.
The machine will carry out a prebrewing cycle.
10:30
11 Feb 04
The display will show:
Prebrewing
Wait please...
Note: the flow of coffee can be shut off at any time by pressing the
"Stop " button (see section 4.6).
10:30
11 Feb 04
Erogating Dose
Stop to end
On completion of the brewing operation
the display will show:
The machine will automatically discharge the used pod into the dreg drawer
and be ready for the next brewing cycle.
4.6
"STOP" dispensing coffee/beverage (Fig.15)
The machine is programmed to automatically stop brewing coffee after it has
dispensed the quantity programmed by the service provider for "espresso and
large coffee".
To stop the flow of coffee ahead of time, press the "STOP" button (Fig.15).
Warning! The flow must be manually stopped if the manual
dispensing function has been selected.
.
10:30
11 Feb 04
Done
Wait please...
4.7

Emptying the dreg drawer

Note: the operator should perform the checking of coffee groun-
ds. Sometimes it is not necessary to empty the dump box as it is
indicated in this section.
Note: the dreg drawer may be emptied only when the machine is
on.
The machine will signal when the dreg drawer has filled to capacity.
The first message warns the user that the dreg drawer must be emptied but the
machine will still allow coffee to be brewed; the display will show:
10:30
Ready
Empty dregdrawer
If the drawer is not emptied of used pods, after a few brewing cycles the
machine will be disabled; in this case the display will show:
10:30
11 Feb 04
Empty dregdrawer
Before coffee can be brewed again, the dreg drawer must be emptied of used
pods (Fig17 - Fig.18).
Note: the dreg drawer will also contain liquid residues as a result
of dripping after coffee or other beverages have been dispensed;
the liquids and pods must be disposed of separately, as appro-
priate. (Fig.19).
The pod trap must be fitted back into the dreg drawer before the
latter can be inserted in the machine.
After emptying the dreg drawer, fit it back in place; the display will show:
10:30
11 Feb 04
Ready
Insert pod
The machine is now ready to make coffee.
Warning! The LAVAZZA pods used with the machine are single-
serving pods to be used for the preparation of one drink only. Do
not use the same pod to prepare more than one drink.
Note: when pulling out the dreg drawer, do not grasp the lower
grill; this should remain in contact with the machine.
4.8
Dispensing steam (Fig.16)
Steam can be used to froth milk for cappuccino and also to heat
beverages.
Danger of scalding! The steam may be preceded by brief sprays
of hot water. The steam wand may reach high temperatures: avoid
touching it directly with your hands.
Before dispensing steam make sure that:
1 the machine has warmed up;
2 the steam wand is directed over the large cup rest grill.
Press the steam button (Fig.15) for a few seconds to discharge any water left
in the steam wand; shortly only steam will issue from the nozzle. The display
will show:
10:30
11 Feb 04
Steam
Stop to end
11 Feb 04
• 21 •

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents