Table of Contents
Advertisement
4.7
Electrode positioning
To verify the correct position of the ignition electrode (Fig. 12), you
need to separate the combustion head from the rest of the burner.
Proceed as follows:
loosen the 4 screws 3)(Fig. 11) and remove the cover 1);
remove the screws 2) from the two sliding bars 5);
install the extensions 15) and re-screw the screws 2);
remove the two screws 4);
pull back the burner on the sliding bars 5) of about 4";
disconnect the electrode lead, then unthread the burner com-
pletely from the sliding bars;
remove the screw 1)(Fig. 13) and extract the inner part 2) of
the head;
check the correct position of ignition electrode, as shown in
Fig. 12.
Measures must be respected.
WARNING
Re-install all components with reverse procedure.
20044771
Installation
1/ 20"
1
2
20
GB
D10453
D10444
Fig. 12
Fig. 13
Advertisement
Table of Contents
