Table of Contents
Advertisement
6.3
Opening the burner
Disconnect the electrical supply from the bur-
ner.
DANGER
In order to open the burner, proceed as follows:
loosen the 4 screws 1) (Fig. 42) and remove the cover 2);
install the 2 extensions 9) on the sliding bars 4) and re-screw
the screws 8);
6.4
Closing the burner
In order to close the burner, re-install all components with reverse
procedure:
remove the 2 extensions 9) and re-screw the screws 8) on the
sliding bars 4);
push the burner up to approximately 4" from the pipe coupling;
reinsert the electrode lead and slide the burner as far as the
stop.
D10449
Maintenance
9
8
2
1
7
35
GB
remove the screws 3) and pull back the burner on the sliding
bars 4) of about 4";
disconnect the electrode lead, then unthread the burner com-
pletely from the sliding bars;
remove the screw 6) and extract the inner part 5) of the head.
Fix the screws 3) to secure the burner to the combustion head;
fix the 4 screws 1) to install the cover 2).
Connect the electrical supply from the burner.
WARNING
6
4"
4
5
1
3
Fig. 42
20044771
Advertisement
Table of Contents
