Avery Dennison AP 4.4 User Manual page 8

04/09 Rev. 5.02-01
Inserting Fan-folded Material
As an alternative to roll material, you can
use fan-folded material:
1. Open the front cover.
2. Release the printhead pressure lever (1).
3. Position the fan-folded material behind the
printer (fig. 1).
4. Guide the material over the material
unwinder roller. Push the material guide up
to the edge of the material, without pin-
ching the material.
5. Continue by following steps 6 to 8 as des-
cribed above in section
Material on page 6.
USER MANUAL
AP 4.4 – AP 5.4
Inserting Roll
1
8
Setup