Filter Control; Filter Factory Setting; Cleaning; Elro High Pressure Cleaning Hpc - ELRO 2300 Series Operating Instructions Manual

4.12 Filter control

Soft water must be used for lid cooling. If soft water is not available, the
appliance can be operated with a water softener (filter). Make sure that only
water for the lid cooling flows through the filter and that ONE filter is installed
per appliance!
The customer is responsible for the water quality.

4.12.1 Filter factory setting

This filter has a water hardness 28dH (carbonate hardness in °KH) and a filter capacity for a total hardness
of 28°KH (partial desalination): 3750 litres are preset.
If another filter is used, the filter capacity must be determined according to the filter manufacturer's
instructions (table / diagram) taking into account the water hardness. Generally, a distinction is made
between complete desalination (total hardness in °GH) and partial desalination (carbonate hardness in °KH).
5

Cleaning

Please refer to and follow the cleaning procedure presented in the previous chapters. This ensures the
reliable functioning of the appliance.
This appliance is made of high-grade stainless steel. For the cleaning, use mild, commercial detergents, soft
cloths or brushes. Use the detergents according to their instruction leaflet. Do not use metal objects or other
items which can scratch, corrode or cut the surface.
Lid seal
5.1

ELRO High Pressure Cleaning HPC

It is possible to clean the appliance with a high pressure cleaner under the following conditions.
5.2

Long non-use

If you do not use the appliance for a long time, leave the appliance lid open. You can lubricate the cooking
chamber with a cloth.
X101923E
*)
Clean the appliance only when it has cooled sufficiently. Empty the cooking
chamber completely, and dry with a cloth.
Make sure that there is no fat is in the basin before cleaning.
Do not damage the seal during cleaning. Only use nonabrasive tools or
cloths. Check the seal for tears and cuts. If the seal is damaged, it must be
replaced by ELRO After Sales Service.
After appliance cleaning, lubricate the dry, detergent-free seal with glycerine.
Turn off the appliance with
chamber. Take into consideration that other kitchen appliances can be
damaged during the high pressure cleaning process!
The mobile appliance must always be separated from mains supply
(electricity, water, steam)! For mobile appliances, make sure that you never
hold the high pressure jet under the appliance and under the media
connections protection hood! The protection hood must be closed!
When cleaning the appliance, the plug must never be immersed or sprayed
with water. Dry the plug after cleaning.
You can clean the appliance with high pressure from above and from the
sides (never from below / behind)!
The following parameters must be observed:
• Maximum pressure 10'000kPa (100bar)
• Maximum water temperature 80°C
• Maximum water flow through rate 15l/min
• Minimum distance from appliance 150mm
• Flat jet nozzle ≥ 35°
Filterwechsel vorbereiten
=> Restmenge < 50 Liter!
(A) 4 seconds, and empty the cooking
Hinweis
24