STIEBEL ELTRON SB 302 S Operation And Installation page 19

.CZ`<<`.HC
.CZ`<<`.HC
8.3.4 Fitting the thermal insulation
SB 602 AC and SB 1002 AC
Insert the anode indicator extension through the whole in the
»
cover plate.
8.3.5 Fitting the thermometer
Insert the thermometer as far as it will go and align it.
»
qqq Z`. <é<`VHC HB
8.3.6 Checking / fitting the signal anode
SB 302 S and SB 402 S
Risk of damage
!
The appliance may not be operated without a
consumption indicator or with a damaged one,
otherwise water will leak out once the anode
is depleted.
1
1 Transport protection
2 Signal anode with consumption display
Remove the transport protection.
»
Check the consumption display for transport damage.
»
SB 602 AC and SB 1002 AC
Risk of damage
!
When operating the cylinder without consumption
indicator, leave the plug in the threaded hole.
Pull the plug out by simultaneously pushing the pressure
»
ring down.
Push in the open pipe end of the consumption indicator until it
»
bottoms out.
Affix the label "Signal anode label" in a clearly visible position
»
on the thermal insulation.
2
Z Z ’ Z  ’