Advertisement
Attach Screen to Arm Assembly
1.
Insert two bolts (BB) into top two holes of Adapter Plate. Leave approximately 1/4" of exposed thread (do not fully
tighten).
2.
Lift the display and hook the two bolts (BB) in grooves on top of the Mounting Head (Figure 4).
3.
Insert two bolts (BB) in bottom two holes of the Mounting Head, securing it to the Adapter Plate.
4.
Then tighten all four bolts with the Allen Key.
NOTE: For demonstration purposes, the wall has been omitted from the illustrations.
ATTENTION: This procedure requires two persons. Ensure that the arm is set to its maximum negative tilt
prior to attaching the display.
Display Panel
Cable Cover Attachment
1.
Route the electrical and data cables along the Arm Assembly and secure in place using the provided Cable Covers
(Figure 5).
NOTE: Ensure enough slack is provided to allow for vertical and horizontal move before attaching the
Cable Covers.
Adapter Plate
Arm Assembly
Head Mount
Figure 4
Cable Covers
Figure 5
Bolts (BB)
5
Advertisement
