Advertisement
Assemble Display Bracket
1.
Slide the Adapter Brackets onto each end of the Adapter Rods (Figure 2).
Mount Display Bracket to Display Panel
1.
Place the assembled Display Bracket on the back of the display with one Adapter Bracket aligned with a set of vertical
mounting holes (Figure 3).
2.
Slide the other Adapter Bracket in or out until it aligns with the second set of vertical mounting holes.
NOTE: The Adapter Plate should be horizontally centered on the back of the flat panel display.
NOTE: There are eight positions for flexibility. Move the Adapter Brackets to desired location. Adapter
Brackets can be flipped around (if required).
3.
Tighten Adapter Brackets to Adapter Rods using four bolts (AA) with a Phillips Head Screw Driver.
4.
Attach the Adapter Brackets using four mounting bolts (A - P) and four square washers (U).
NOTE: Bolt size will depend on thread pattern on flat panel being installed.
5.
Once aligned, tighten all screws down with a Phillips Head Screw Driver.
Bolts (A – P)
(size depends on display)
Washer (U)
Adapter Rod
Display Bracket Assembly
Display Back
Adapter
Plate
Bolts (AA)
Figure 2
Figure 3
4
Adapter Bracket
(A – P)
(U)
M6 or M8 Washer Hole
M4 or M5 Washer Hole
Advertisement
