Strong FS Series Product Data Sheet

Product Data Sheet
FS SERIES
Fully Assembled Rack System w/ DC Fans
SR-FS-SYSTEM-DC-42U
Product Overview
Package Contents
A Top Cover
B Welded Frame
C Front Door - Tinted Glass
D Side Panel (x2)
E Rear Panel
F Bottom Cover
G 2U Rack Shelf (x8)
H 2U Vented Panel (x8)
I Low-Profile Fine-Floor Casters (x4)
J DC Fans (x2)
K Locking Door Latch
L Door Latch Plate
M Ground Studs (x4) (located on top and
bottom covers in the rear of rack)
N Nylon Washers (x3)
O Pre-installed Bushings (x3)
Key Features
• 1000 lbs. max load capacity
• Tamper resistant lock on reversible tempered
glass front door
• Removable side and rear panels for easy
serviceability
• Front and rear rails tapped with 10/32
threads to allow for mounting of components
in front or rear of rack
• Superb ventilation system - Strategically
placed fans* & vents to ensure that
equipment stays cool
• Low profile, fine floor, locking casters
• Fits through a standard doorway even with
the casters on
• Lifetime limited warranty
*Notes: Fans are always on, we recommend they
are plugged into a switching surge
protector or AV receiver.
Please be sure to check with local
authorities in regard to code
requirements for compliance.
If the door is rubbing against the base,
then add the necessary amount of nylon
washers (N) onto the bottom hinge pin
to allow for extra clearance.
A
B
C
K
L
CAUTION!
When loading equipment into cabinet, ensure that
the casters are locked, and load heavier equipment
at the bottom of the rack.
Reversing Front Door
Tools Required:
#2 Phillips Head Screwdriver
Reversal Steps
1. Remove both side panels (D), and open the front door (C).
2. Remove the Door Latch (K) by removing the clamp with a
#2 Phillips screwdriver, and slide the latch out of the door.
3. Remove the Latch Plate (L) using a #2 Phillips screwdriver.
4. Pull the top and bottom hinge pins out of the locking
position and slide the door up and out. Remove the
bottom, pre-installed bushing (O).
5. Insert the bushing into the opposite bottom hinge pin hole.
6. Flip the door over, align the bottom hinge pin over the
grommet, and slide into place. Repeat for the top hinge pin.
7. Attach the Latch Plate (L) to the rack opposite the door
hinges using a #2 Phillips screwdriver.
8. Insert the Door Latch (K) into the door, and secure with the
clamp using a #2 Phillips screwdriver.
9. Close and latch the door, and reattach the side panels (D).
M - Ground Studs (not shown)
N - Nylon Washers (3) (not shown)
O - Pre-installed Bushings (3)
J
E
D
G
H
F
I
© 2017 Strong Racks Rev: 170321-0940
TM