When the Status button is pressed on a Node, the current status of the radio
signal will be displayed briefly by the LEDs. The Node will then indicate the
status of the radio signal after each radio transmission for a period of 10-
minutes. If the Node has not yet joined the network, it will change its radio
interval to approximately one second and search for an available network.
Device
Function
Supervisor or Node
Reset
Cellular Supervisor &
Put the network into Deployment mode/extend Deployment
Mesh Supervisor
mode. Display the current status.
Cellular Supervisor
Take a reading and send existing data immediately
Display the current status, then indicate signal strength
Node
every radio cycle for 10 minutes
TABLE 8: Status Button Functions
MODEL 8900 SERIES GEONET WIRELESS DATA HOSTING SYSTEM | NETWORK INSTALLATION | 21
8:
Status Button Action
Press and hold until both LEDs
illuminate (~10 seconds)
Press and release
Press and release
Press and release