TRENDnet TI-PG541i User Manual page 17

TRENDnet User's Guide
IP Address
This field indicates the IP address of the Switch.
Subnet Mask
This field indicates the subnet mask of the Switch.
Default Gateway
This field indicates the default gateway of the Switch.
This field displays the MAC (Media Access Control) address of the
MAC Address
Switch.
The serial number assigned by manufacture for identification of
Serial Number
the unit.
Management
This field displays the VLAN ID that is used for the Switch
VLAN
management purposes.
CPU Loading
This field displays the percentage of your Switch's system load.
This field displays the total memory the Switch has and the
Memory
memory which is currently available (Free) and occupied
Information
(Usage).
This field displays current date (yyyy-mm-dd) and time
Current Time
(hh:mm:ss).
Refresh
Click this to update the information in this screen.
Basic Settings
General Settings
System
Management VLAN
To specify a VLAN group which can access the Switch.

The valid VLAN range is from 1 to 4094.

If you want to configure a management VLAN, the management VLAN should
be created first and the management VLAN should have at least one member
port.
© Copyright 2016 TRENDnet. All Rights Reserved.
Host Name
The hostname is same as the SNMP system name. Its length is up to 64 characters.
The first 16 characters of the hostname will be configured as the CLI prompt.
Default Settings
The default Hostname is TI-PG541I
The default DHCP client is disabled.
The default Static IP is 192.168.10.200
Subnet Mask is 255.255.255.0
Default Gateway is 0.0.0.0
Management VLAN is 1.
CLI Commands
Node Command
configure Reboot
configure hostname STRINGS
configure interface eth0
eth0 Show
eth0 ip address A.B.C.D/M
eth0 ip address default-
gateway A.B.C.D
eth0 ip dhcp client
(disable|enable|renew)
TI-PG541i
Description
This command reboots the system.
This command sets the system's network
name.
This command enters the eth0 interface
node to configure the system IP.
This command displays the
configurations.
This command configures a static IP and
subnet mask for the system.
This command configures the system
default gateway.
This command configures a DHCP client
function for the system.
Disable: Use a static IP address on the
switch.
Enable & Renew: Use DHCP client to get an
IP address from DHCP server.
eth0
7