Advertisement
SWF EMBROIDERY MACHINE
Picture 3
Picture 4
Picture 4
Picture 5
─ Ver.2009 1st
3. Remove the Arm Protection Plate & the Side Cover
1)Use a (-) driver to remove the arm protection
plate.
2)Use a (+) driver to remove the arm side cover B.
Refer to Picture 3
4. Set the Presser Foot Driving Cam
1)On the menu of OP Box, select "TOOL"
→ "PF UP/DOWN" in order to down the presser foot.
2) Set the angle plate to 150 degrees.
Refer to Picture 4
3) Insert the presser foot cam JIG pin in order of
the presser foot cam collar, the presser foot
driving cam base and the take-up driving cam base.
Refer to Picture 5
4) Adhere the presser foot driving cam to the side
of take-up driving cam. And then use a 4mm
T-wrench to assemble it
Refer to Picture 5, 6
────────────────────── SunStar Co., Ltd ─
presser foot
cam
JIG pin
Caution
) At this time, check that the cutting
part of presser foot driving cam collar matches
with the cutting part of presser foot driving
cam.
Advertisement
