BluStream Multicast ACM200 Api Documentation page 9

Video Wall Commands
Video wall configurations will be setup in the ACM200 Web GUI
Each video wall setup will include the following:-
• Video wall creation = Each Multicast system can include up to 9x seperate video walls (01-09)
• Configuration = Individual configurations of screens within a video wall. An example of a configuration would be all screens as-
signed as a single video wall, all screens configured as individual displays, multiple video walls configured within a larger video
wall (video wall groups – see below) (01-09)
• Groups = A video wall group is the 'Grouping' of Multicast receivers within a video wall allowing simplified source selection and
configuration recall of more than one Multicast Receiver at the same time (A-J)
Video Wall 1 Configuration 1
Example of control commands
VW01C01APPLY (will apply video wall configuration 1 above to all Receivers)
VW01C02APPLY (will apply video wall configuration 2 above to all Receivers)
VW01C01GaFR002 (will apply video configuration 1 and switch all screens to Transmitter 002
VW01C02GbFR006 (will apply video configuration 1 and switch group b screens [orange] to Transmitter 006
When recalling video wall configurations the following applies:
Characters:
idx = [01...09] - Video Wall Index / Number
cidx = [01...09] - Config Index / Number
COMMAND DESCRIPTION
Apply Config to Video Wall
Set Grouped Output from single Source INPUT:yyy
Apply Single Screen Config to Video Wall HxV Location
Set Single Screen HxV Output from single Source INPUT:yyy
ALL video wall status
Single Video Wall status
For full Video wall API commands including VW setup please see 'HELP COMMANDS' on page 17 of this manual.
contact
support@blustream.co.uk / support@blustream.com.au
Video Wall 2 Configuration 2
COMMAND
VW idx C cidx APPLY
VW idx C cidx G gidx FR yyy
VW idx C cidx S HhhVvv
VW idx C cidx S HhhVvv FR yyy
VWSTATUS
VWidxSTATUS
ACM200
RESPONSE
Apply config: Configuration cidx
[SUCCESS] Done
[SUCCESS] Done
[SUCCESS] Done
(See status example at end of document)
(See status example at end of document)
API DEVELOPMENT
09