Mitsubishi Electric PUHY-M200YNW-A1 Service Handbook page 356

[8-13 Parts Replacement Instructions ]
[Drain pan mounting procedure]
*Reuse the drain pan mounting screws that were removed from the replaced drain pan. (M5 x 16 mm with a nylon washer)
(1) Screw down the right drain pan with two screws. (See Figure 7.)
(2) Screw down the left drain pan with two screws. (See Figure 8.)
(3) Hook the pipe cover on the left drain pan. (See Figure 9.)
(4) Hold the external temperature sensor wiring to the left drain pan with two cable ties. (See Figure 10.)
(5) Screw down the front panel. (See Figure 11.)
Pipe cover
Figure 9
Front panel
Figure 11
BS_08_E
Drain pan (right)
Two screws
Insert the tab on the drain pan into
the notch on the center pillar, and
screw down the drain pan.
Figure 7
Hook the pipe cover
on the drain pan.
Two screws
Drain pan (left)
Hook the left drain pan on the
protruded part on the right drain pan.
Figure 8
Drain pan (left)
Cable tie
Outside temperature sensor wiring
Figure 10
101
chapter 8 -