Step 5 - Installing The Canopy - Hunter Carera Installation And Operation Manual

STEP 5 - INSTALLING THE CANOPY

WARNING
• When removing the #6-32 x
3/8" screw that was tempo-
rarily installed in STEP 4 -
WIRING THE FAN, do not al-
low the hanger bracket to
rotate in the ceiling plate as
this could cause the fan to
fall.
• Failure to complete sub-
steps 1 through 3 could
cause fan to fall.
1. Being careful to not allow the
hanger bracket to rotate in the
ceiling plate, remove the single
#6-32 x 3/8" screw that was in-
stalled in STEP 4 - WIRING THE
FAN, sub step 3.
41419-01 10/29/2002
2. Raise the lower canopy up over
the hanger bracket and align the
three holes in the lower canopy
with the three holes in the ceil-
ing plate and the three threaded
screw holes on the hanger
bracket as shown in Figure 5a.
You may need to slightly spread
the tabs apart on the lower
canopy to align them with the
holes on the ceiling plate and
hanger bracket.
3. Install and securely tighten the
three #6-32 x 3/8" screws.
4. Raise the upper canopy and align
the three screw holes in the up-
per canopy with the three
threaded holes in the ceiling
plate. Install and tighten the three
#6-32 x 1/4" screws as shown
in Figure 5b.
Ceiling Plate
#6-32 x 3/8"
screws (3)
Lower Canopy
Hanger
Bracket
Figure 5a - Attaching Lower Canopy
and Hanger Bracket to Ceiling Plate
Upper Canopy
#6-32 x 1/4"
screws (3)
Lower Canopy
Figure 5b - Attaching Upper Canopy
®
17