Hunter Carera Installation And Operation Manual page 13

Positioning
Plug
Screw
Pin
TM
Trilobular Ball
Hanger
Bracket
Lower Canopy
Upper
Canopy
Pipe Setscrew
Fan
Figure 3d - Inserting Pipe through
Canopy and Trilobular TM Ball
41419-01 10/29/2002
with the matching holes on the
pipe as shown in Figure 3e. Insert
the pin into the two holes in the
Wedge
pipe so that the pin is centered
evenly in the hole, see Figure 3e.
6. Align the cutouts in the Trilobular
ball with the pin.
7. Slide the Trilobular
pipe until it hits the pin.
8. Insert and tighten the positioning
screw into the Trilobular
Figure 3f.
WARNING
Pipe
• Failure to complete the
steps above properly could
result in the fan falling.
Positioning Screw
Pin
TM
ball up the
3 1/2" Pipe
TM
Figure 3e - Pipe & Trilobular
ball. See
TM
assembly components
Figure 3f - Pipe, Wedge, Pin &
Trilobular TM
®
Wedge
Trilobular TM
Ball
Ball
TM
Ball assembly.
13