Rps Status Led; Port Mode Led - HP A5120 EI Series Installation Manual

LED mark

RPS status LED

The RPS status LED shows the operating status of the RPS DC input.
Table 19 RPS status LED description for the non-PoE switches
LED mark
RPS
Table 20 RPS status LED description for the PoE switches
LED mark
RPS

Port mode LED

The port mode LED indicates which type of information is being shown by the network port LEDs.
You can use the port LED mode switching button to change the type of port information that is displayed.
Table 21 Port mode LED description
LED mark
Mode
Status
Flashing green (1 Hz)
Steady red
Flashing yellow (1 Hz)
Off
Status Description
Both the RPS DC input and the AC input are normal, or an RPS is
Steady green
connected and the AC input is normal.
The RPS DC input is normal, but the AC input is disconnected or
Steady yellow
has failed.
Off No RPS is connected.
Status Description
Steady green Both the RPS DC input and the AC input are normal.
The RPS power input is normal, but the AC input is disconnected
Steady yellow
or has failed.
Off The RPS power input is abnormal or no RPS is connected.
Status
Steady green
Flashing green (1 Hz) (available
only for the PoE switches)
Steady yellow
Description
The switch is performing power-on
self test (POST).
POST has failed.
Some ports have failed to pass POST.
The switch is powered off.
Description
The network port LEDs are showing port rates.
The network port LEDs are showing the status of
PoE power supply on the ports.
The network port LEDs are showing duplex
modes.
73