Setting The Router Depth For Single Depth Only - TACKLIFE PTR01A User Manual

ROUTER ACCESSORY INSTALLATION - cont'd
5. Turn the router base locking knob clockwise until it locks into the locking knob hole in the motor
housing.
NOTE: Hand tighten only.
6. If required, attach a vacuum to the vacuum adaptor (7).

SETTING THE ROUTER DEPTH FOR SINGLE DEPTH ONLY

Depth of cutting is controlled by sliding the router base up and down on the guide rods and locking it
in place.
1. Loosen the depth stop locking knob (Fig. 15) (1) counter clockwise and raise the depth stop rod
(2) to its maximum height and then retighten the locking knob to hold the depth rod in position (Fig.
16).
2. Rotate the plunge action turret (3) until the shortest stop (4) is under the depth stop rod.
3. Lift the height adjusting lever (5) upward to allow the upper section of the router base to slide on
the plunge rods (6) (Fig. 17).
4. Slide the upper section of the router base downward to obtain the desired depth of cut.
5. Push the height adjusting lever downward to lock the cutting depth.
6. Install the cutting bit or router bit (Fig. 3).
Fig. 16
- 20 -
Fig. 17