Cutting Tips - TACKLIFE PTR01A User Manual

WARNING: Before turning the power switch ON, make sure you are holding the
!
tool firmly with both hands. Starting torque will cause the tool to twist.
7. Turn the switch ON.
Fig. 8
PRACTICE CUTS USING THE FREEHAND CUTTING GUIDE – cont'd
8. When the motor is up to full speed, slowly tip the tool to an upright position, letting the bit cut into
the workpiece (Fig. 9). Once the tool has reached the upright position and the bit has cut through
the workpiece, slowly move the tool in a clockwise direction using slow steady pressure to make
the cut.
NOTE: Except for cutting around outlet boxes in drywall, always cut in a clockwise direction.
9. When the cut is complete, turn the tool OFF, wait until it comes to a complete stop and remove it
from the workpiece.
!
DANGER: Do not attempt cutting around outlet boxes in drywall until:
1. All electricity in the vicinity of electric wires has been disconnected by either turning the
breaker OFF or removing the fuses.
2. You have read the instructions on the following page entitled "CUTTING OUTLET OPEN-
INGS IN DRYWALL".

CUTTING TIPS

The rotating cutting action of the bit will cause a slight pull to the left when cutting. Natural variations
in the structure of wood will cause the bit to "wander". This tendency will be magnified when applying
too much pressure to the bit.
- 14 -
Fig. 9