Changinging The Collet; On/Off Switch - TACKLIFE PTR01A User Manual

CHANGINGING THE COLLET

The cutting bits for this tool are locked into place with a collet nut (1) and collet (2)
(Fig. 4). 1/8" and 5/32" collets are used for holding 1/8" and 5/32" cutting bits and hobby tool
accessory bits. The 5/32" square collet is used to connect the flexible shaft to the tool. The 1/4"
collet is supplied for holding 1/4" drywall and small router bits.
To change from one collet size to the other:
1.
Remove bit from the tool.
2.
Turn the collet nut counter clockwise until it can be removed from the motor shaft (3) (Fig. 4).
3.
Pull the collet out of the motor shaft and insert the new collet.
NOTE: Each collet is the same on both ends, so either end can be inserted into the motor shaft.
Re-install the collet nut and slightly tighten it by hand.
NOTE: Tightening the collet nut without a bit in the collet will cause the collet hole to become
smaller and make installing bits difficult. When storing the tool with no bit installed, leave the
collet nut loose.

ON/OFF SWITCH

This spin saw is equipped with a convenient ON/OFF switch (1) located on the top of the tool
handle (Fig. 5). To turn the switch ON, slide the switch outward. To turn the switch OFF, slide the
switch inward.
Fig. 4
Fig. 5
- 10 -