Installing The Circle Cutting Guide - TACKLIFE PTR01A User Manual

CUTTING OUTLET OPENINGS IN DRYWALL – cont'd
10. The completed electrical box cut out will be accurately and neatly cut (Fig. 11).
NOTE: Always move the cutting bit in a counter- clockwise direction around the outlet box. The
natural tendency of the cutting bit to move to the left will make it easier to cut close to the box.
Fig. 11

INSTALLING THE CIRCLE CUTTING GUIDE

The circle cutting guide accessory is ideal for precision cutting of circles. This circle cutting guide must
be attached to the freehand cutting guide.
1. Install the assist handle and install and adjust the freehand cutting guide on the tool as illustrated
in Fig. 1, 2 & 7.
2. Insert the externally threaded circle cutting guide mounting insert (1) into the bottom of the
freehand cutting guide (2) (Fig. 12).
NOTE: Make sure the scallops of the insert mate properly with the scallops inside the freehand
cutting guide foot.
3. Place the circle cutting guide mounting hole (3) over the externally threaded circle cutting guide
mounting insert (4).
NOTE: Make sure pointed pivot pin (5) is pointing away from the tool.
INSTALLING THE CIRCLE CUTTING GUIDE – cont'd
4. Screw the internally threaded circle cutting guide mounting disc (6) onto the externally threaded
circle cutting guide mounting insert and hand tighten.
- 16 -
Fig. 12