Cutting Bit Applications - TACKLIFE PTR01A User Manual

ADJUSTING THE FREEHAND CUTTING GUIDE – cont'd
3.
Before starting to cut, double check the bit depth. Make sure the cutting guide is at a right
angle to the bit and securely tightened. Double check the collet to make sure the bit is
securely fastened.
!
WARNING:
For safety reasons, the operator must read the sections of this Owner's Manual
entitled "GENERAL SAFETY WARNINGS", "POWER TOOL SAFETY", "SPECIFIC
SAFETY RULES", "EXTENSION CORD SAFETY" and "SYMBOLS" before using
this spin saw.
Verify the following every time the spin saw is used:
1. The cord is not damaged.
2. The bit is securely fastened in the collet.
3. The bit is sharp and in good condition.
4. Safety glasses, hearing protection and dust mask are being worn.
Failure to adhere to these safety rules can greatly increase the chances of
serious injury.

CUTTING BIT APPLICATIONS

Cutting Bit Type
1/4" (soft wood*,
fibreglass and laminate)
1/4" (windows and
doors)
1/8" (soft wood*,
fibreglass and laminate)
5/32" All purpose
(not included)
1/8" Ceramic tile
(not included)
Soft wood* refers to spruce, pine and fir (SPF)
Material and Thickness
Fibreglass and laminate up
to 1/4" and soft wood* up to 1"
Drywall, gypsum board up
to 5/8"
Fibreglass and laminate up
to 1/8", soft wood* up to 1"
All materials and thicknesses
listed in this chart plus sheet
metal up to 1/32" thick
"Porous" ceramic wall tiles
up to 3/8"
- 12 -
Recommended
Speed control
Cut Feet per
wheel setting
Minute
3–6 1 ft./min
3–6 1.5 ft./min
3–6 1 ft./min
0.5 to 1.5 ft./min.
3–6
depending upon
the material
3–6
0.5 ft./min.