Speed Control Switch; Adjusting The Freehand Cutting Guide - TACKLIFE PTR01A User Manual

SPEED CONTROL SWITCH

The spin saw is equipped with a variable speed control located below the ON/OFF switch. To
run the tool at the slowest speed, rotate the speed control wheel (2) to number "1" (Fig. 6). To
increase the tool speed, rotate the speed control wheel in the opposite direction. Maximum
speed will be achieved at "6".

ADJUSTING THE FREEHAND CUTTING GUIDE

1. Adjust the freehand cutting guide depth by loosening the depth gauge locking screw (1) and
moving the cutting guide foot (2) up or down as required (Fig. 7).
NOTE: Set the foot so the cutting bit protrudes beyond the bottom of the cutting guide 1/8" more
than the thickness of the material being cut. For example, if you are cutting 5/8" drywall, the bit
should protrude 3/4" beyond the bottom of the cutting guide.
2. Securely tighten depth gauge locking screw.
NOTE: Hand tightening is normally adequate. If you use a screwdriver (3), do not over tighten
the locking screw.
Fig. 6
Fig. 7
- 11 -