Re-Crating And Shipping; Lifting Instructions; Cleaning - Challenge CHAMPION 370 TC Instructions And Parts Manual

6.3 Re-Crating and Shipping

Save the packing materials and braces. All packing blocks and hardware should be saved or
reproduced in order to ship the machine again. If the machine is not repacked as it came from the
factory, damage will result when trucked.

Remove the knife before shipping.

Brace the back-end of the table to the skid using a 2x4.

Use a skid larger than the outer tip-to-tip dimensions of the machine.

Block the counter-weight according to page 12, Figure 2 and 3

Remove the hydraulic breather cap and plug with a ¾ NPT plug.

Always lift and transport from the front of the machine. The carton has lifting instructions, so
it must be placed properly on the skid.
Challenge is not responsible for an improperly packed machine. The skid and packing materials are
available for purchase from Challenge.

6.4 Lifting Instructions

Professional riggers should do unpacking, handling, and positioning. If handling or unpacking is a
problem, your dealer or a local trucking facility should be able to supply or recommend a qualified
rigger. This 3750-lb/1701-kg machine should be moved with experienced people and the proper
equipment. Do not risk personal injury or damage by attempting to move machinery with makeshift
equipment or inadequate manpower.
Lifting straps may also be used to lift the machine by placing the straps around the front and rear of the
table. When straps are used in this way, wood blocks must be placed beside the lead screw to prevent
damage, (Figure 4). A bent lead screw will cause the backgauge to bind. The lead screw cover must
also be removed. Do not strap around the lead screw cover.
The backgauge should be positioned all the way to the front of the table and straps placed as close
the machine body as possible. Gently lift the cutter, remove the skid and carefully place the cutter on
the floor.

6.5 Cleaning

Wipe down the table and bare metal surfaces with a non-flammable solvent such as CRC or blanket
wash. The table surface is cast iron and will rust if left unprotected. Coat the table with a non-
abrasive wax. A Cutter Care Kit, p/n 16077, with cleaner and wax, is available thru your Authorized
Challenge Dealer. The protective film on the console may be removed. Never clean console with
petroleum based solvents. Damage will result. See also Cleaning under Maintenance Guide on
page 37.
Figure 4
6.0 Installation & Setup
13